Spirit System

Today I was flying my M4 with the Spirit GT and Geolink module. I setup a teacher/trainer mode on my Frsky X20S. I had the altitude limit set on a switch to 0 meters, so that when flipping the switch the current altitude was the harddeck.
The student could only use the sticks and no switches.
While ...

Í'm trying to put aero firmware on my GT unit. Nor my MAC or W10 laptop can find the unit with either the wifi link or usb connection.
with the Spirit settings program for the heli it's not a problem.
I set the usb port to com 2, but still no succes.
Any help appreciated.

ZeXx86 wrote:We were finally able to find a computer with the issue and already fixed it.
I believe that tomorrow there will be new software version.

Big thumbs up for the support guys.

I’m on W10 64bit. I also have the same problem with the wifi link.
I can set up the heli but can’t do the diagnostic test.

Today I wanted to do a diagnostic spectrum analyzer test but every time I started the test I got the message that the connection was unstable. I checked the connections several times and restarted the pc and the heli. Same result.
I could still set everything up, bec test worked etc.
What could be ...

My bad, its a GT.
I changed the telemetry settings to kontronic esc and now it works. It’s in the manual but I selected Hobbywing ESC.
With the Hobbywing telemetry sensor I didn’t get the rpm right. Now, with the Telem uni cable I have all the info I need.

I did everything mentioned in the manual, esc with latest non Vbar firmware, Spirit GTR setup as per manual, S-bus cable in S-bus2 port of R7008SB, telemetry setup in transmitter but nothing on the screen.
Any suggestions on how to get telemetry data on the screen?

I tried the latest version 3.6.2 and it didn’t crash.
Thumbs up for the developers.

ZeXx86 wrote:We found the problem and working on solution now. It will be ready during following week.

Great, tumbs up

I tried recalibrating the compas a couple of times. When I put the compas in calibration mode I get a solid green light when I start up. I don’t get 3 rapid blue flashes. When I start moving the heli I get blue flashes after a couple of minutes. It’s different from what the manual states.