Spirit System

If I enlarge the window so that I get the Live view, the program crashes as soon as I open the diagnostics tab. If I reduce it again so that the view is not displayed, the program runs without any problems

Is it possible to use the Spirit Lua for EdgeTX together with another telemetry device via S. Port? Or is it possible to operate the FrSky receiver as an F. bus and then operate another telemetry device via the S. port of the receiver in addition to the Lua integration?

I have also connected it as described but the Unisens does not get any power. If I also connect power and ground to the Unisens and only connect the signal line and ground to the Sat 1 port of the Spirit GT, the Unisens gets power but the sensors get no information. I have tried it in the SM ...

Hello,

how do I connect the Unisense-E as a telemetry device to the Spirit GT? And which protocol do I set in the Unisense software?

Kind regards, Norb

I generally only fly in banks 1 and 2 and adjust the parameters there. Bank 0 always has a normal setup with a low head speed. I have only adjusted parameters such as flight style, turn rate, feed forward and gyro sensitivity.

A colleague of mine was also able to reproduce this on his setup. He ...

I had a similar problem last weekend with a FrSky X8R with S.BUS / S.Port. In my case, the problem occurred in conjunction with the EdgeTX script. I landed twice briefly to adjust parameters and after the second time the heli no longer accepted any control inputs. I only regained control after ...

Hello,

today there will be new Lua script for EthOS.

However, a new LUA for ETHOS does not help me with my problem. I use a Radiomaster TX16s with EdgeTX. Up to version 3.7.1, the script ran without problems in conjunction with the R-XSR with uniACCST firmware in the F.BUS protocol. With 3.7.2 ...

I use the KST BLS-915 V8 cyclic and BLS-905X V2 on tail with the Spirit GT. I only hear a lot of noise on the OMP M7 when it's moving towards the cyclic end, but this is due to the very tight-fitting ball ends.

With the classic Jive, not with the Pro version, the yellow/orange cable must be plugged into the center because otherwise the satellite input of the Spirit will be damaged. The Jive outputs the power at the telemetry port on the outer port and not in the middle like most controllers

I have updated my Spirit GT on OMP M7 to version 3.7.2 and now the Lua integration on my Radiomaster TX16s is extremely slow. It takes 10-15 sec. until a page is built. I use a FrSky F.BUS receiver (R-XSR with uni ACCST firmware). Before the update with 3.7.1, the script ran without any problems and ...