Spirit System

Yesterday I tried the new version 4.0.0r3 of the Spirit Settings Android version, using the Spirit-Link (BT), and found that the channels do not appear correctly in the diagnostic section. I clarify that the channels appear correctly in the Windows version of the Spirit Settings and that all my ...

I also request information about how to adjust the altitude during RTH
Last Sunday this function saved my helicopter, thank you very much for that

I wish to activate the rescue mode through a separate channel, could you please indicate the steps to follow in the activation procedure
Currently I activate the rescue through the use of banks, but I would like to know the method of separate channel that announces as a novelty in the manual, thank ...

Hi, I have tested the Geolink in a Goblin 380 with good results
Now, I want the Aero version because I think the Return to Home function combined with the Altitud Limit is the ticket for FPV flight
I'm sure many Spirit users think the same way I do

Ok, thank you for your answer, my landings are now much better, no bouncing at all, no landing damage

For the lack of comments on my post, I guess I do not write it in an understandable way, so I attach a copy of a post on the same subject, I hope it serves

I would appreciate your help adjusting the aero unit for a smoother landing
I want maximum stability and low response to the transmitter commands
To get this I lowered the default Direction Control Rate in the Stabi tab to the minimum.
And also lowered the Feed Forward value in the Advanced Tab
With ...

I have been using the spirit aero for several weeks (20 flights approximately) I am very satisfied with its performance in strong wind conditions, I hope to try the new firmware next weekend, thank you very much

In the manual, Stabi Tab, in the part that explains the Rescue and Stabilization modes, says:
"If using these modes, be sure your model is initialized on a flat surface, not tilted to any
side. Do not tilt the model for more than 5 seconds after initialization . It can be initialized
in normal or ...

Thank you very much, I hope that the next update will include this function