Cyclic Phase

Rcpassa · Fri 19. Feb 2016 23:57:40

What should this setting be for help with a 3 headed blade? 60?

Sat 20. Feb 2016 0:05:55

For many multirotor heads cyclic phase is 0°, because phasing is done mechanically.
So you have to check what your rotor head require to operate correctly.
Manufacturer of the rotor head should tell you all the details.

Adrian · Sat 20. Feb 2016 14:57:54

Have a look on my explanation to find right phase:
http://www.spirit-system.com/phpBB3/vie ... 481#p13481

Rcpassa · Sun 21. Feb 2016 0:19:52

What would the cyclic phase setting need to be on a goblin 380 three bladed heli or a oxy3 Qube?

Coco66 · Mon 22. Feb 2016 19:57:32

AFAIK, both manufacturers specify that to go from their two blades head to their three blades head the only needed change is to reduce the cyclic gain.

Rcpassa · Mon 22. Feb 2016 22:04:54

it seems ambiguous with the spirit flybarless

Coco66 · Mon 22. Feb 2016 22:11:24

Where did you see any ambiguos note?
The FBL has nothing to do differently than with a two blades head, if everything has been done mechanically... why should Spirit be different?

Rcpassa · Mon 22. Feb 2016 22:23:57

it ambiguous because tomas has mentioned that in some cases it doesn't need to be lowered with three blades...

Mon 22. Feb 2016 22:37:24

Spirit has adaptive regulation that is able to tune itself to a certain degree. So this is reason, why it can fly well with the same cyclic gain.
But generally you have to lower the gain. So everything is true.