Hello, can someone help me put bank selection with a DX6i radio and satellite DSMX?
Thank you
Bank selection with DX6i
Hello,
the easiest way is this:
1. Unassign Gyro Gain function in the General/Channels window.
2. Assign Banks function to the Channel 5
3. Set Gyro Gain in your transmitter to 0% and 100% - this will allow Bank 0 and Bank 2. 50% is for Bank 1, but DX6i has only two state switch (but you can use Mix in your transmitter to allow all 3 banks)
From now, your Rudder Gain will be configured in the software in the Sensor tab and your Bank switching will work.
If it will work correctly you will see in the Diagnostic tab that Banks are changng when you are moving with the switch.
the easiest way is this:
1. Unassign Gyro Gain function in the General/Channels window.
2. Assign Banks function to the Channel 5
3. Set Gyro Gain in your transmitter to 0% and 100% - this will allow Bank 0 and Bank 2. 50% is for Bank 1, but DX6i has only two state switch (but you can use Mix in your transmitter to allow all 3 banks)
From now, your Rudder Gain will be configured in the software in the Sensor tab and your Bank switching will work.
If it will work correctly you will see in the Diagnostic tab that Banks are changng when you are moving with the switch.
Spirit System developer
For testing the banks, you have to close the software. When software is running, banks are switched through this.
Spirit System developer