This is a Second Request
Can you please tell me why the GeoLink will not go into Calibration Mode
According to the Manual I should be getting a Blue Blinking light when I power the unit back up outside
I only get a Solid Green Light, even when I move the Heli around a Sphere
So what is the problem
John
COMPASS CALIBRATION
Hello,
you can continue in your original thread:
https://www.spirit-system.com/phpBB3/vi ... =20&t=6119
Unfortunately I have no idea about your setup so any additional information would be helpful.
Normally it should just work, so with no additional details I can only recommend to unplug everything that is not necessary from the Spirit unit.
It could be anything from bad wiring to damaged GeoLink or Spirit.
Is GeoLink new?
Are you still able to open GeoLink window and see details such as GeoLink firmware version?
It is not necessary to do calibration outside. It will work anywhere.
you can continue in your original thread:
https://www.spirit-system.com/phpBB3/vi ... =20&t=6119
Unfortunately I have no idea about your setup so any additional information would be helpful.
Normally it should just work, so with no additional details I can only recommend to unplug everything that is not necessary from the Spirit unit.
It could be anything from bad wiring to damaged GeoLink or Spirit.
Is GeoLink new?
Are you still able to open GeoLink window and see details such as GeoLink firmware version?
It is not necessary to do calibration outside. It will work anywhere.
Spirit System developer