I received a Spirit 3 today which comes with firmware V4.0.6 installed (Firmware, not PC software!). When connected to the PC (software V4.0.6) it is not possible to perform any downgrades. What is the reason for this, resp. what is different to V4.0.5, resp. is it safe to use with Jeti integration V4.0.4r2?
Regards Philipp
Firmware V4.0.6?
Hello,
reason is that these units are coming with the most recent chip versions that are not supported by old firmwares. Downgrading would brick the unit, so it does not make sense.
Firmware will be released following week. It is safe to use with the latest integration files. Similar situation happened already multiple times, for this reason we do not offer old firmwares for some units.
Because there is extreme chip shortage some chips are out of stock for next 2 years, so using alternatives are needed. This hardware revision has the most powerful sensors by the way.
reason is that these units are coming with the most recent chip versions that are not supported by old firmwares. Downgrading would brick the unit, so it does not make sense.
Firmware will be released following week. It is safe to use with the latest integration files. Similar situation happened already multiple times, for this reason we do not offer old firmwares for some units.
Because there is extreme chip shortage some chips are out of stock for next 2 years, so using alternatives are needed. This hardware revision has the most powerful sensors by the way.
Spirit System developer
