Version 1.3.0 released!

[ZeXx86]

Version 1.3.0 was released!

It brings many new features and improvements:

• Spirit Pro support!
• New sensor data processing.
• Improved flight behavior and precision.
  
• Improved Governor:
  
  • Max. parameter range was extended (has to be reconfigured).
    
  • New feed forward algorithm for immediate response and superior performance.
    
  • Support for more sensors.
    
  • Spoolup rate can be configured with higher precision.
    
  • Governor is activated at 40%+ TC.
    
  • Governor can be enabled/disabled between banks (check settings between banks!).
    
  • Improved bailout feature.
• Throttle settings are available for disabled governor too:
  
  • Frequency can be configured to obtain much better performance.
    
  • Throttle Range - Max. value can be configured to 150 for disabled governor.
• Channel Mapping was improved to display current channel values.
  
• Improved Wizard:
  
  • Saving of the settings is available anytime with CTRL+S.
    
  • Unit can be disconnected anytime during the process of setup.
• BEC tester was improved to determine if the power supply is sufficient.
  
• New bank comparison feature.
  
• New bootloader.
  
• New secure format for the firmware.
  
• New firmware flash procedure:
  
  • Much more secure (encryption, data integrity verification).
    
  • Firmware can be flashed easily even when any kind of failure occured previously (with the new recovery mode).
• Improved Rescue and Stabilisation mode:
  
  • Stabilisation hovering level can be manipulated to a higher extent.
    
  • Rescue (Normal) has 1.5s climb out as with Acro mode.
    
  • Improved precision with more level corrections.
• Improved UDI protocol compatibility.
• Support for next channel in PWM connection with Spirit Pro.
  
• New Rudder end-points setup.
• Additional features with Spirit Pro..

Changes from previous version 1.2.0 in your settings:

• All settings from the previous version are untouched. You do not need to re-configure anything.

You can download it from our web pages!

New JETI Binary file is available here:
http://spirit-system.com/dl/jeti/Spirit.bin

[ZeXx86]

New update 1.3.1 released right now!

• New parameter Acro Delay for the Rescue (Normal) mode.
• Fixed minor problems with the software:
  
  • Bank comparison will show Holding performance.
  • Software is installed to "Spirit Settings" directory.
  • Flashing procedure is faster.

[ZeXx86]

Jeti file was updated to reflect changes in 1.3.1 version.

You can download it here:
http://spirit-system.com/dl/jeti/Spirit.bin

[ZeXx86]

New update 1.3.2 released right now!

• Governor Improvements:
  
  • More precise spool up algorithm.
  • Throttle frequency of 333Hz is running faster now.
  • New RPM Sensor Filter parameter.
  • New Autorotation Bailout parameter.
• Software Improvements:
  
  • Updated tooltips for some parameters.
  • Fixed configuration problem with Acro Delay on the Windows platform.
  • Software can recognize wider range of COM ports on the Windows platform.
  • Application name was changed on the OS X platform.
  • And many small fixes and improvements.
• Better EX Bus compatibility with REX receivers.
  
• Limit for Main Loop Hang Occured event was increased.

Jeti BIN file can be downloaded here:
http://spirit-system.com/dl/jeti/Spirit.bin