[SOLVED] Spektrum DSMX can't bind

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Angus
Posts: 8
Joined: Wed 04. Nov 2015 3:32:20

for the life of me I can't get the spektrum dsmx to bind, I powered up the system with the BEC and the system usb cable, I updated the latest firmware to 1.3.1 and follow the wizard. It asks what type of receiver you have and I chose DSMX, next page it asks to bind in a typical manner, power down plug in bind plug to elv/pit/ail power up and turn on radio with bind button pressed down (both with the system usb plug in and out, instructions do not refer to plugged in our taken out) all I get is one flash of the light on the dsmx and a slow flash on the spirit to a steady light. tried this 20 to 30 times and now I'm hairless :mrgreen: :mrgreen:

any help would be appreciated

Angus
Top
Ben M
Posts: 46
Joined: Sun 02. Nov 2014 14:27:38

Did you do a save before binding? If you did not, go to the Backup tab and click on Save.
Top
Angus
Posts: 8
Joined: Wed 04. Nov 2015 3:32:20

yes that was it, quite that easy in the wizard steps or the instructions, still not sure how I did it but I got it to bind. thanks for the reply

Angus
Top
Post Reply

Return to “Support”