It is not obvious how to calibrate the "governor min" and "max" fields to the required values. I suggest that there be "set" buttons, such that the user (1) disables ESC/motor, (2) sets radio to min value (i.e. throttle hold), (3) presses "set min", (4) sets max value (full throttle), (5) presses "set max" in the GUI.
Further, I do not like the current failsafe value. Currently it seems to output a very low value (maybe -150%) when signal is lost, which is acceptable but annoying (ESC constantly beeps). Earlier I had it outputting full throttle when signal was lost! (This was when I was adjusting the throttle min/max points in the governor GUI.) The fail-safe position should either be min-throttle or be adjustable by the user!
While you're at it, please allow calibration of all channels. It would make set-up much easier.
Governor calibration
Upcoming version will bring many changes, including different Throttle Range settings.
So everything mentioned is significantly improved.
So everything mentioned is significantly improved.
Spirit System developer
What receiver type do you using?
Spirit System developer
Brilliant.
Gr-12L. The problem started when I accidentally reset the receiver (I use a receiver mixer to set throttle range so that it shows up correctly on the TX) and had to recalibrate channels. I checked without the Spirit connected, and the failsafe was doing the right thing (I used a servo as a "PWM meter" instead of the motor).
Gr-12L. The problem started when I accidentally reset the receiver (I use a receiver mixer to set throttle range so that it shows up correctly on the TX) and had to recalibrate channels. I checked without the Spirit connected, and the failsafe was doing the right thing (I used a servo as a "PWM meter" instead of the motor).