Spirit Profile Beta couple things

In case you would like to see some new feature in the software you can share it right here!
You can also report issue or odd behavior here.
Post Reply
User avatar
Coco66
Posts: 433
Joined: Sun 26. Jul 2015 8:17:50
Location: Madrid, Spain / Torino, Italy

Hi, I have the feeling that in Servo Travel Correction the Maximum and the Minimum are swapped.
My non-zero values are for low stick but they appear here in the first part, the Maximum area. I think they should be shown below in the Minimum area.

One other small thing... with 2.0.0 the Failsafe information can be saved to the unit (for some receiver typoes), but I don't see it here in the printed settings detail. Would be nice to have.
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1
Top
ZeXx86
Site Admin
Posts: 12782
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Hi,

thank you for the report.
This issue is caused because of your special firmware where it must be swapped because of your rotor head.
So it is not officially supported yet.
Spirit System developer
Top
Post Reply

Return to “Wishlist / Bug report”