Hi,
I do not own a Wifi-module yet, but I am wondering what will happen if there are more than one Wifi-modules active.
Are there different SSIDs? How is the IP-address determined?
The app shows WIFI [ 192.168.4.1], is this a fixed IP-address?
Are parameters such as IP or SSID modifiable?
Regards,
Alexander
Spirit Wifi-Link
Once you connect to a Wifi-Link and get to 192.168.4.1 with a browser, you can change the SSID so to differentiate the different units you have and use understandable codes ("Spirit_Warp", "Spirit_G500" a.s.o.).
Not sure if they have already natively different SSIDs, but the IP addresses will always be the same anyway in each network, so 192.168.4.1 will always connect you to the WiFi-Link module of the network you are connected to.
Not sure if they have already natively different SSIDs, but the IP addresses will always be the same anyway in each network, so 192.168.4.1 will always connect you to the WiFi-Link module of the network you are connected to.
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1
OK, I understand, thank you.
An initial common SSID is no problem if the SSIDs can be modified. Hope the corresponding password can also be modified
.
This way there is no problem using the same IP-address for all units.
Regards,
Alexander
An initial common SSID is no problem if the SSIDs can be modified. Hope the corresponding password can also be modified
.This way there is no problem using the same IP-address for all units.
Regards,
Alexander
Hello,
there are different SSIDs by default, similarly to BT modules.
You can modify it in the settings in any way as you wish.
IP address (AP side) is always 192.168.4.1, but in case of Client side (if used) the module will obtain a second IP in dependency on your network.
You can find these information in the PDF guide.
there are different SSIDs by default, similarly to BT modules.
You can modify it in the settings in any way as you wish.
IP address (AP side) is always 192.168.4.1, but in case of Client side (if used) the module will obtain a second IP in dependency on your network.
You can find these information in the PDF guide.
Spirit System developer