Rudder delay setting

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Helibelly
Posts: 32
Joined: Thu 28. Aug 2014 16:56:34

Hi, I was wondering what would be a good number to set the rudder delay to on my trex 450. I am using a JR ds290g tail servo. The speed is 0.07 seconds. It is currently set to 10.
Thanks, Eric.
Top
thestructured
Posts: 157
Joined: Thu 24. Dec 2015 20:13:20

Try it at 5 or 6. Basically, lower it until the tail stops feeling loose and laggy.
Top
Helibelly
Posts: 32
Joined: Thu 28. Aug 2014 16:56:34

thestructured wrote:Try it at 5 or 6. Basically, lower it until the tail stops feeling loose and laggy.
OK will try that so, thanks
Top
Post Reply

Return to “Support”