It brings many new features and improvements:
- Major governor algorithm improvements:
- Performance was greatly enhanced by adding dynamic factor into the regulation loop.
- Governor is not dependent on the RPM Sensor anymore.
- In case of RPM Sensor malfunction, governor will still work (with lower performance).
- RPM Sensor failure reported in the Log.
- RPM data noise detection feature is more precise. It can distinguish a real noise in a better manner.
- Head speed can be changed in any situation with no performance influance.
- Realtime Tuning feature:
- Brand new feature that will allow you to set 20 parameters and 4 functions from any transmitter!
- Possibility to assign 3 different realtime parameters and functions at the same time.
- Support for Channel data pass-through to the CH0 servo output.
- Support for Vibration Analysis during flight (In-Flight).
- Parallel usage along with the Bank Switching or Jeti Integration with no problems.
- Please check the Online Manual for more details.
- Adaptive Rudder stopping algorithm:
- Stopping behavior is automatically enhanced during flight to gain the best performance.
- Stopping is automatically updated for both sides separately.
- If overshooting is detected, it will be eliminated as possible.
- Channel layout:
- Support for 10 channels (Spektrum DSM2/DSMX, Futaba S-BUS, SRXL/SUMD, Jeti EX Bus).
- Support for 8 channels (PPM).
- Futaba S-BUS protocol:
- Possibility to set Failsafe directly in the unit (Channels window).
- Jeti EX Bus protocol:
- Order of telemetry data was changed to make it compatible with DeviceViewer software (Please refresh telemetry variables in your transmitter).
- Spektrum DSM2/DSMX protocol:
- Fixed compatibility with Wifi-Link module - unwanted Binding problem.
- Setup Wizard:
- Helicopter profiles were updated (Oxy 3, Goblin 380).
- Connection reliability was improved for the USB interface and Wifi-Link.
- Rescue safety protection:
- When initialized with engaged Rescue mode, the swashplate will signalize the event (Warning by Pitch-Pumps in the loop).
- Software improvements:
- Tooltips with more details.
- Connection was improved when transmittion is unstable.
- Minor useability tweaks.
Only minor tuning of the Governor Response and Holding performance parameters might be needed.
Futaba S-BUS users should set Failsafe in the General/Channels.
Update for the Spirit unit, Wifi-Link and Jeti Integration is available in our Download section.