When I go trough the setup Wizard I don't get the option for channel setup.
I needed to complete the Wizard and then go back to General Tab to set channel assignment.
WIZARD
This is very likely caused, because you are using a PWM connection or Spektrum, where channels are usually unchanged for the basic setup.
So this behavior is wanted to make it as easy as possible.
If a pilot can see options, he can be unsure if they are OK. If there is nothing, you do not have to worry about it.
So this behavior is wanted to make it as easy as possible.
If a pilot can see options, he can be unsure if they are OK. If there is nothing, you do not have to worry about it.
Spirit System developer