Installed Version 2.3 and FW 2.3.1. Changed d
the Servo settings in my TX to standard. But now the bank switching i assigned to channel 5 of the TX and the spirit does not work. When i switch the 3 way switch of channel 5 in the channel and diagnostic tab of the spirit it changes the gyro. Graupner MX20 connection over SUMD.
Peter
Bank switching Grauner Hott
Hello,
you have to swap channel 5 and 7 in the software to default.
It should be Gyro Gain: Channel 5,
Bank Switching: Channel 7
Then everything will be OK. This change is described in the Changelog for 2.3.
you have to swap channel 5 and 7 in the software to default.
It should be Gyro Gain: Channel 5,
Bank Switching: Channel 7
Then everything will be OK. This change is described in the Changelog for 2.3.
Spirit System developer