Tail servo end points

[Necroscope]

I am setting up my first Spirit Pro and have intergration with my DS-16.
While checking everything, I found that my tail wasn't going to it's furthest travel.
I went into Device Manager and found the the servo travel was set to 85%.
So I changed the travel to 100% in both directions. I saw the servo adjusting as I did this.

I the repowered the heli and tried the tail again, but there didn't appear to be any change.
I went back into Device Manager, and found that the new setting had been saved.

I have only checked this on the work bench, not in flight.

Am I misisng something.

[ZeXx86]

Try to increase your Gyro gain. If it is too low, the servo will not reach the end points.