Yes, this ESC is also fully supported. Although it has no Current sensor inside (thus no capacity measurement). But otherwise it is working well.
Is your ESC flashed with the latest firmware? This could be the problem.
ESC Telemetry
Spirit System developer
Hi Spirit pilots,
I am setting up a new Raw 580 with Tribunus 120 V2 ESC and a Scorpion HKIV-4025-110kv motor. I am using DX8 G2 TX with SPM9747 and 4651T satellites. I have selected Tribunus governor (mid) and did not activate the Spirit governor. My throttle curves are: Nor 0,55,55,55,55; S1 - 75,75,75,75,75; S2 - 95,95,95,95,95. The issue is that the TX screen shows that the Nor throttle is at 10%, S1 at 50% and S2 at 80%. The test run shows and feels that these are the actual (very low) percentages.
Please advise- shall I use the ESC airplane mode and activate the Spirit ESC, or there is another option?
Thanks
PB
I am setting up a new Raw 580 with Tribunus 120 V2 ESC and a Scorpion HKIV-4025-110kv motor. I am using DX8 G2 TX with SPM9747 and 4651T satellites. I have selected Tribunus governor (mid) and did not activate the Spirit governor. My throttle curves are: Nor 0,55,55,55,55; S1 - 75,75,75,75,75; S2 - 95,95,95,95,95. The issue is that the TX screen shows that the Nor throttle is at 10%, S1 at 50% and S2 at 80%. The test run shows and feels that these are the actual (very low) percentages.
Please advise- shall I use the ESC airplane mode and activate the Spirit ESC, or there is another option?
Thanks
PB