Spirit pro with graupner optic6 2.4ghz radio

[slavin89]

Dear to all, i've bought a Spirit pro but I'm unable ti use It with my optic6 radio..wich mode I can match Spirit with my radio?

[Coco66]

Well, you will probably need a receiver, no?

Moreover, is it not the Optic6 a Hitec?

[slavin89]

Optic 6 is the radio..but I can't use It direcly White Spirit?..I must to Connect Spirit to optima 6 transmitter of graupner?

[slavin89]

Sorry I wrong title..i tell about hi-tech not graupner

[ZeXx86]

You can use Spirit units with basically any radio including your.
Usually PWM connection is working with all.

It is only dependent on your receiver capabilities.
What is your receiver?

[slavin89]

I use optima 6 receiver bit wich Channel i must to Connect ?..And the Spirit must be' programmed in ppm mode?

[ZeXx86]

Optima 6 receiver has support for PWM connection, so you have to connect it according the PWM scheme:
http://manual.spirit-system.com/index.p ... _.28PWM.29

It should be:

RX.....SPIRIT
------------------
Ch 1.....AIL (ELE/PIT/AIL port)
Ch 2.....ELE (ELE/PIT/AIL port)
Ch 3.....Your ESC
Ch 4.....RUD port
Ch 5.....AUX1 port
Ch 6.....PIT (ELE/PIT/AIL port)

[slavin89]

Sorry but I don't understand ..servo and esc are connected on Spirit and Spirit connected to receiver with One cable or all servo are connected to receiver?

[ZeXx86]

As you can see on the scheme, ESC is connected to the receiver.
Servos always to the unit (ports CH1, CH2, CH3, CH4).

Ch 1 - Ch6 that I have written are from receiver.