Connection to PC

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Romis
Posts: 18
Joined: Wed 27. May 2015 13:04:44

Can`t connect my unit - the red Spirit, to PC. Installed the newest version of software on computer, but don`t remember what version of firmware I have on the unit... what to do?
Top
ZeXx86
Site Admin
Posts: 12836
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

No problem,

in that case you can just flash the latest firmware - in the Backup tab.
In the Connection tab you can see what firmware is in the unit right now.
Spirit System developer
Top
Romis
Posts: 18
Joined: Wed 27. May 2015 13:04:44

ZeXx86 wrote:No problem,

in that case you can just flash the latest firmware - in the Backup tab.
In the Connection tab you can see what firmware is in the unit right now.
Software shows that it could be started only in demo mode, there is no connection from unit to PC.
When installed the new software, it updated the drivers.
Top
ZeXx86
Site Admin
Posts: 12836
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Ah. In that case it does not communicate at all with the unit.
When starting the software please make sure that the unit is fully initialized - Status LED is steady on.

You can review this guide:
http://manual.spirit-system.com/index.p ... dows#Usage
Spirit System developer
Top
Romis
Posts: 18
Joined: Wed 27. May 2015 13:04:44

Thanks! Will try again ..
Top
Romis
Posts: 18
Joined: Wed 27. May 2015 13:04:44

Still can`t connect to computer -
https://drive.google.com/file/d/1hfeXkm ... sp=sharing
Top
Post Reply

Return to “Support”