[SOLVED] No cyclic to left side after 2 min flt in Stab Koax

[ZeXx86]

Ah, that is great.

So maybe just by disconnecting the fan it will all work well.
Could you please disconnect it for a try? It should handle also 3D flight without the fan on your model.

HobbyWing fans are unfortunately creating ultrasound that is disturbing the sensors a lot. For this reason disconnecting it it could be all solved.

[tabbie]

I have removed the fan. Trying again this evening.

[tabbie]

I have flown the heli yesterday, perfect weather.
I changed the following before the flight, removal of the ESC fan hobbywing 100A platinum, I have changed the GEOLINK to a closer position about 10cm away from tailservo. I have wrapped the GEOLINK cable with aluminium foil from a chocolade bar and grounded the foil to the tail boom.

The issue is gone, everything is good now.

(solved)

[enied]

I have flown the heli yesterday, perfect weather.
I changed the following before the flight, removal of the ESC fan hobbywing 100A platinum, I have changed the GEOLINK to a closer position about 10cm away from tailservo. I have wrapped the GEOLINK cable with aluminium foil from a chocolade bar and grounded the foil to the tail boom.

The issue is gone, everything is good now.

(solved)

I did buy a Sunon MC30100V2-A99 fan for my hobbywing 100A V3 platinum and use it. No problems caused by the fan at all.

BR Eugen

[ZeXx86]

That is great! Thank you very much for the message!