Prevent motor spool-up when connected to USB/Bluetooth/Wifi

In case you would like to see some new feature in the software you can share it right here!
You can also report issue or odd behavior here.
Post Reply
jjuk
Posts: 305
Joined: Thu 05. Oct 2017 20:06:35

The motor only needs to spool-up when configuring the governor, so a tick box in the governor setup screen to enable the motor would be good to stop accidental spool-ups. The motor will turn off when governor setup screen is exited.

In all other screens, the motor will ALWAYS be disabled, regardless of throttle setting on the Tx.
Top
Shonkonray
Posts: 33
Joined: Wed 12. Sep 2018 18:34:47

Then you wouldnt be able to use the vibration analysis!
Top
jjuk
Posts: 305
Joined: Thu 05. Oct 2017 20:06:35

Shonkonray wrote:Then you wouldnt be able to use the vibration analysis!


Ah yes, forgot about that. Enable the motor for that test too. But everything else should be disabled.
Top
Post Reply

Return to “Wishlist / Bug report”