AR8010 and sxrl

[Stanley1]

Hi all
New guy here with an issue

Setting up my 700x with an ar8010t and spirit pro using the sxrl connection

When I run through the set up and get to the servo screen with the green bars the only thing I can get moving is the right and left aileron servos but with the rudder stick???

Nothing else moves on the heli and no other green bar moves except for aileron going from -50 to +50

Any ideas?

[ZeXx86]

Hi Stanley,

please make sure you have SRXL/SUMD configured in the Receiver type parameter.
Then you can check the Channels, there you have to see Channels 2 to 6 from up to bottom. Possibly you can assign Throttle to Channel 1 too.