Telemetry for Vibrations nor accurate or do i miss someting?

[ripcurl777]

Hello Support,

today i finetuned the Vibrations on my Rex500 in the Spectrum log i habe Vibratiosn around 30-51% on each of the Axes.
As far as Good, may be better, will tune my 500er

But on the Telemetry Screen (OpenTX) in Fuel% the Vibrations are only between 0-4% so:

1. Is there a Muliplcator needed? (Multiply x 10)
2. Ar these % in Fuel only the exceeding % (over 50%) of Vibrations meaing that 1% in Fuel means 51% in real?

Thanks.

[ZeXx86]

Hello,

vibrations are measured in a very different way in both cases.
Your radio is displaying excess vibrations - vibrations that were not filtered and could have an effect on the flight performance.
So it is looking good, since in a hard maneuvers there will be always some additonal vibrations.