Hallo togehter!
I'm trying to set the telemetry on my Goblin 280. In the tab for the gear ratio I would have to enter 1: 1, but this will not be saved. Can someone tell me what I have to enter here for the right configuration?
Thank you and best regards
Robert
Goblin 280 and Telemetry
Hello,
you should just enter what is stated in the Goblin manual. Then save the settings and all will be OK.
For sure correct ratio is not 1 : 1 for this model.
you should just enter what is stated in the Goblin manual. Then save the settings and all will be OK.
For sure correct ratio is not 1 : 1 for this model.
Spirit System developer
hi Thomas
the ratio in fact is 1:1 because is a direct drive helicopter
the motor is coaxial to the main shaft
anyway seem the correct parameter is to put
sensing divider: 12
gear ratio: 1.00
the ratio in fact is 1:1 because is a direct drive helicopter
the motor is coaxial to the main shaft
anyway seem the correct parameter is to put
sensing divider: 12
gear ratio: 1.00
Yes, you are right.
I forgot to mention Sensing Divider because this is configured according the motor poles.
I forgot to mention Sensing Divider because this is configured according the motor poles.
Spirit System developer
no worries
enjoy your flights
enjoy your flights