CC & Talon - ESC telemetry DIY cable

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Bladecrasher
Posts: 98
Joined: Wed 16. Mar 2016 15:58:50

I followed the directions and made the 10k ohm resistor part and it seems to be working fine. This was on an Oxy3 using a uSpirit. I only had 1/4 watt resistors. It would seem like there isn't going to be much current in this connection but wanted to post this question.

Is 1/4 watt sufficient?
Top
ZeXx86
Site Admin
Posts: 12836
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Hello,

yes, it should be enough. It is only for signal path where nearly no current is present.
Spirit System developer
Top
Post Reply

Return to “Support”