[SOLVED] full cyclic at 40% input

[Armin]

Hi,

just setup my spirit system.
Even without any Dual-Rate configured in Graupner MX-16 Tx and in the Diagnostic Tab 100% in both directions on Roll and Nick I reach the final roll/nick rate at approx. 40% input at the stick (same in the diagnostic tab) --> I can only see movement of the servos in the range of -40% to +40%.
If I reduce Dual-rate to 50% in Tx same max cyclic pitch rates can be reached, but reaction seems slower. Pitch works fine from -100% to +100% with continuous movement.
Is this a normal behavior? Especially that max cyclic is reached at 40% input seems incorrect for me. Any ideas?

Thanks,
Armin

[enied]

This is normal.

BR Eugen

[Armin]

Thanks Eugen!
Everything works fine!

Armin