Hello service team, would like to use Micro Spirit's governour and telemetry from HOTT (RX 12L). And as ESC - YGE 35LV. Therefore I have to connect SUMD (CH6) to RUD; Telemetry(CH5) to SYS. That's fine.
I guess it is correct to use red wire from YGE (after YGE TexY - and of course coming from blue connector) and connect it to AUX1 from Micro Spirit for RPM signal. But which pin is it at Spirit? And how get I ESC's telemetry data into micro spirit in that combination ?
Or is it easy as it looks like - just plug in blue connector from YGE (of course using YGE TexY in between) to AUX1 ?
ESC has been set to use ext. governour
thanks and kind regards
Siggi
Spirit System
Support forum