Graupner Receiver, SUMD, Hott Integration and USB Connection

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Capelini81
Posts: 14
Joined: Mon 03. Aug 2015 13:43:42

Hey Folks,

i´m a bit confused about my "old" Setup on an old Spirit and an Graupner GR-24. I've connected them via SUMD form Receiver Port 8 to RUD port on Spirit. Everything works fine but now I want to integrate Telemetrie and got here some questions:

In the Wiki "Hott integration" you are writing, that I need to connect Spirit SYS Port with the Telemetrie port of the Receiver. For Telemetrie ok, but you are also writing that the SUMD Channel transmission will work over the Telemetrie Port. - Is this correct? So I can or must unplug the Channel transmission cable on the RUD port?

Will the UBS interface Work parallel to the Channel transmission on the SYS Port? Otherwise I won't be able to configure Spirit in this case.

Ore do I need to connect the Channel transmission from the Receiver separate in this case?

Thanks
Marcel
Top
enied
Posts: 107
Joined: Mon 15. Oct 2018 4:19:55

Hi,

1) connect the ESC to the Spirit Satellite Port #1 (special cable required)
2) connect the Telemerty Port of the GR-24 to the SYS Port (special cable required)

This will allow to get telemetry data AND configure the Spirit using your transmitter.

To use the USB Cable: disconnect the HoTT integration cable from the SYS Port and plug in the USB cable. Now you can configure the Spirit or Geolink via USB. Do NOT use an Y-adapter on the SYS Port.

In no case you have to disconnect the SUMD cable.

BR Eugen
Top
Capelini81
Posts: 14
Joined: Mon 03. Aug 2015 13:43:42

enied wrote:Hi,

1) connect the ESC to the Spirit Satellite Port #1 (special cable required)
already done with Unisens
enied wrote:2) connect the Telemerty Port of the GR-24 to the SYS Port (special cable required)
clear so far
enied wrote:This will allow to get telemetry data AND configure the Spirit using your transmitter.

To use the USB Cable: disconnect the HoTT integration cable from the SYS Port and plug in the USB cable. Now you can configure the Spirit or Geolink via USB. Do NOT use an Y-adapter on the SYS Port.
I will configure Spirit with my Computer and transmit the Channels via SUMD at the SYS Port - This won´t work , correct?

Ihm clear about the wiring but not where the SUMD Signals will be transmitted
enied wrote:BR Eugen
KR
Marcel
Top
enied
Posts: 107
Joined: Mon 15. Oct 2018 4:19:55

The SUMD cable needs to be connected from GR-24 channel 8 to the Spirit RUD Port. It never needs to be disconnected.

BR Eugen
Top
Capelini81
Posts: 14
Joined: Mon 03. Aug 2015 13:43:42

enied wrote:The SUMD cable needs to be connected from GR-24 channel 8 to the Spirit RUD Port. It never needs to be disconnected.

BR Eugen

Thanks,

I read the Wiki wrong...

KR
Marcel
Top
Post Reply

Return to “Support”