And channels 1 to 8 with telemetry in the radio.Serenus wrote:What receiver configuration you have chosen in OpenTX? Did you take the one with telemetry? Can you send a screenshot?
Sent from my Redmi Note 7 using Tapatalk
How to get opentx integration to work
-
Heliupman567
- Posts: 10
- Joined: Sun 10. May 2020 20:45:39
Sent from my Redmi Note 7 using Tapatalk
-
darkhorseweb
- Posts: 1
- Joined: Wed 06. May 2020 5:29:18
I am using the RX-8 recv and Spirit 2. Short history, I upgraded my flybarless spirit gen1 to spirit 2 on my Goblin 570.
OpenTX Integration was working with original spirit, since upgrading to spirit 2, exact same setup as before openTX integration is not working anymore. Will wait to firmware 3 comes out, most likely will be fixed then.
OpenTX Integration was working with original spirit, since upgrading to spirit 2, exact same setup as before openTX integration is not working anymore. Will wait to firmware 3 comes out, most likely will be fixed then.
-
Heliupman567
- Posts: 10
- Joined: Sun 10. May 2020 20:45:39
Glad it's not just me that is running into this issue. I have all the latest firmware installed on my radio, and have tried a few receivers now in Access and D16 mode, and I still cannot get any data back to the radio..Serenus wrote:I am using OpenTx 2.3.7 and on my spirit pro the 2.8 version and telemetry and integration is working with my R-XSR receiver.
Which versions you are using? Perhaps your versions are not working together.
Serenus... May I have a picture of how you have you little reciver wired up.. I have one on my Oxy 4, and directly soldered onto the sbus pad so I didn't have to use the inverter cable, but I haven't figured out how to wire it for telemetry?
Sent from my Redmi Note 7 using Tapatalk