Geolink drift

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
FrankFuss
Posts: 114
Joined: Tue 17. Mar 2015 3:10:20

Nmony wrote:Tail shaft does not look bent but I will remove and replace.
Replace the bearings also.
Top
Nmony
Posts: 53
Joined: Sun 13. Sep 2020 16:01:41

FrankFuss wrote:
Nmony wrote:Tail shaft does not look bent but I will remove and replace.
Replace the bearings also.
Why?
Top
Nmony
Posts: 53
Joined: Sun 13. Sep 2020 16:01:41

New Tail-Blades fitted, does this look better?
Image

I have not replaced the tail shaft yet but i have it if required
Top
buttles
Posts: 156
Joined: Tue 16. Jun 2015 14:37:10

The (big) difference between tail blades on and off suggests to me the blade mounting holes in the hubs are stretched out?
Top
Nmony
Posts: 53
Joined: Sun 13. Sep 2020 16:01:41

buttles wrote:The (big) difference between tail blades on and off suggests to me the blade mounting holes in the hubs are stretched out?
I'll have a look at that.
Top
Nmony
Posts: 53
Joined: Sun 13. Sep 2020 16:01:41

I've checked the Tail Blade grips and the bolt holes look perfect, no elongation.
Top
Nmony
Posts: 53
Joined: Sun 13. Sep 2020 16:01:41

@ZeXx86 - any further advice on this please?

Kinda losing faith with this product - I've also been trying to setup telemetry and integration with my DX8, I'm using all the right cables and an SRXL2 receiver with a Castle Talon 90 and I cannot get the motor RPM and sometimes the ESC does not start the motor. I cannot get the integration to work at all, the setup guide on the website does not work.

Thanks
Top
FrankFuss
Posts: 114
Joined: Tue 17. Mar 2015 3:10:20

Nmony wrote:
FrankFuss wrote:
Nmony wrote:Tail shaft does not look bent but I will remove and replace.
Replace the bearings also.
Why?
Any play in the bearing can cause your vibration problems.
Top
ZeXx86
Site Admin
Posts: 12836
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Hello,

I am very sorry for delayed reply.
Vibration level looks good if it is similar with Y axis too.

Unfortunately we are very busy, so it is hard to satisfy everybody.
We can ship you new Spirit unit for comparison.

Please open new thread for your other issue. It is certain we will resolve both.
Spirit System developer
Top
Nmony
Posts: 53
Joined: Sun 13. Sep 2020 16:01:41

ZeXx86 wrote:Hello,

I am very sorry for delayed reply.
Vibration level looks good if it is similar with Y axis too.

Unfortunately we are very busy, so it is hard to satisfy everybody.
We can ship you new Spirit unit for comparison.

Please open new thread for your other issue. It is certain we will resolve both.
Thanks for the reply, I understand you are busy.

How do I go about getting a unit for comparison?

I will post all the axis graphs tomorrow.
Top
Post Reply

Return to “Support”