can't get spirit2 to operate after attempt to flash 3.2

[mb-1953]

I have many units and in the process of updating, 1 of them didn't reboot at the end and wont respond. I tried recovery several times, the blue light flashes but when done there is no response. Does it need to be sent back? or am I missing something?

[ZeXx86]

Hello,

sorry for the troubles. The recovery process is working normally, am I right?
Will the firmware bootup in the end, at least immediately after flashing?

Very likely sending is not needed. It can be resolved remotely.

[mb-1953]

Tried recovery with geolink disconnected and it recovered. all good now.