I have a strange behaviour on my initialization pitch pump, I have several other helis where all three cyclic servos pitch pump at the same time when I wait for the initialization confirmation.
I have a Soxos Strike 7 that flies great but it is the only heli that does this, setup with 120 degrees reversed swash, Futaba S-Bus receiver type.
so far I have check the following in the software, unit orientaion, servo wiring to the specified ports, all seem to be configured properly with no change.
did I not go through the setup wizard all the way - 100%? and this is telling me something?
anyone else experience this behaviour? I am hoping it is just a step I missed, otherwise heli flys great.
Initializing pitch pump on elevator servo only
Hello,
have you activated Rescue ? This is, I think, the sign that you have activated rescue by a switch - please look up if it is so -
Also you shouldn't start flying the heli by activating rescue at start up - look at the online-manual -
http://manual.spirit-system.com/index.php?title=Manual
Best regards
Matthias
have you activated Rescue ? This is, I think, the sign that you have activated rescue by a switch - please look up if it is so -
Also you shouldn't start flying the heli by activating rescue at start up - look at the online-manual -
http://manual.spirit-system.com/index.php?title=Manual
Best regards
Matthias
Hello,
it is enough to view Flight Log.
There is some error saved in the log.
it is enough to view Flight Log.
There is some error saved in the log.
Spirit System developer
-
rotorhead51
- Posts: 29
- Joined: Mon 06. Aug 2018 2:10:40
Tomas
after my last flight I tried to view the log through my Android tablet without any luck, I was at the field and wasn't sure how to view the log.
Can I save the log to my "documents" file on the tablet? do I need a Wifi connection for this feature to work.
I understand that you loose the log after disconnecting the lipo battery, it would be helpful if it was saved until I got home to connect to my PC.
Hi Mattes61
I can confirm that rescue was not activated, and is not assigned to any switch, but thanks for your feedback.
John
after my last flight I tried to view the log through my Android tablet without any luck, I was at the field and wasn't sure how to view the log.
Can I save the log to my "documents" file on the tablet? do I need a Wifi connection for this feature to work.
I understand that you loose the log after disconnecting the lipo battery, it would be helpful if it was saved until I got home to connect to my PC.
Hi Mattes61
I can confirm that rescue was not activated, and is not assigned to any switch, but thanks for your feedback.
John
-
rotorhead51
- Posts: 29
- Joined: Mon 06. Aug 2018 2:10:40
after I came home from work I decided to plug in my Spirit 2 to read the log, I saw the warnings that the cyclic ring and tail limits were reached so I decreased my values slightly and rebooted the unit and got the three servos to pitch pump at the same time. looked at the log again and it calibrated fine with a good health message, mind you it was not a flight but just a quick start up.
I will have to see if I can get my log downloaded on my tablet after my next flight at the field to verify my current settings.
Thanks for directing me to the logs Tomas.
John
I will have to see if I can get my log downloaded on my tablet after my next flight at the field to verify my current settings.
Thanks for directing me to the logs Tomas.
John