High vibration levels with open tx integration after update
-
leatherface
- Posts: 72
- Joined: Wed 08. Oct 2014 11:21:06
- Location: sydney,australia
I updated my spirit units from 2.8 to 3.2.2,and also updated the integration firmware to 3.2.Now my vibration levels(reported as fuel on the open tx telemetry) are very high,where as before they were quite low.Nothing has been changed on the models.Is it likely this is a bug and nothing to worry about?
Hello,
as you can see in the ChangeLog vibration measurement has been changed.
Now it is more like the Vibration Analysis in the software.
If the level is under 50% then it is all OK.
as you can see in the ChangeLog vibration measurement has been changed.
Now it is more like the Vibration Analysis in the software.
If the level is under 50% then it is all OK.
Spirit System developer