Hello,
I want install a Spirit 2 on my TDR with an old YGE 90HV. On the Wiki I saw that I have to connect the RPM Signal line to the RPM Pin but where I have to connect the brown/orange (they both are connected with each other) wire? Can I connect them to EXT Pin?
Is there a possibility to connect the RPM signal to the Spirit RS that I can use the RPM signal to display on my JETI DS-14II main screen?
How to connect YGE 90HV to Spirit RS?
Hi
It is the red cable from esc program (rpm)going to the rpm pin on spirit,the brown cable is going to - on some pin on fbl,dasent matter whitsh -pin you choses.The orange is for yge progcard.
Then you can see the rpm in Jeti tx telemetry.
I think you looking at the connection for Vbar,its different from Spirit.
//Latjo
It is the red cable from esc program (rpm)going to the rpm pin on spirit,the brown cable is going to - on some pin on fbl,dasent matter whitsh -pin you choses.The orange is for yge progcard.
Then you can see the rpm in Jeti tx telemetry.
I think you looking at the connection for Vbar,its different from Spirit.
//Latjo
No this pin is for jeti sensors,the E1 port -pin or anyone else exept for sys port can you use.DanielB80 wrote:Thank you, so I can connect the brown (ground) cable to the EXT Pin under the RPM Pin!
You can allso connect the -(ground)to the becs- or if you use a 2s battery to -pole,the - ground is the same in
the whole system.
//Latjo
Thanks for the answer, I thought that EXT Pin I can not use, this was my general question here!
I will use one of the ground from the satellite ports, this I don't need, the rest is totally used because of external BEC and I don't want to use a V-Cable Adapter.
I will use one of the ground from the satellite ports, this I don't need, the rest is totally used because of external BEC and I don't want to use a V-Cable Adapter.
Happy flyings