Wiring Spirit Pro
-
Crashpilot1977
- Posts: 18
- Joined: Sat 04. Apr 2020 19:22:50
What do I have to do if I plug a supply cable into the receiver and a cable into the Spirit AUX? Will there be a mass loop?
-
Crashpilot1977
- Posts: 18
- Joined: Sat 04. Apr 2020 19:22:50
I have just measured the master and slave cable of the HW-100A V3 and there is a galvanic connection to the two cables with each other. So they use the same mass/potential in the BEC/ESC.
They are connected in parallel. No idea how other manufacturers handle this with master and slave. I don't think there are any potential differences here, so it works.
In my opinion, this is a doubling of the cable cross-section.
They are connected in parallel. No idea how other manufacturers handle this with master and slave. I don't think there are any potential differences here, so it works.
In my opinion, this is a doubling of the cable cross-section.