[SOLVED] Spirit GT 3.3.2 not initializing

[weixelgeist]

Transmitter: Radiomaster TX16S with Multimodul and firmware 1.3.2.86
Receiver: Frsky X8R with ACCST D16 FCC protocol
Spirit GT with firmware 3.3.2

The Spirit has problems to initialize, 1 of 3 attempts fail.

[ZeXx86]

Can you describe how it will fail? Is it same as your collegue - by wrong channel centering?

[weixelgeist]

No, it does not initialize. The blue led does not blink at start, it is permanently on. The servos are not responding. All is dead.

[ZeXx86]

In that case I will send you guide for fixing the problem in private message.

Solution should be easy.

[weixelgeist]

Did you send me a message? I did not receive a message.

[ZeXx86]

Yes, now it was sent to you with instruction.

[Storchy]

I have the same problem, sometime, not often, the blue led is solid and no servo movement is possible. The YGE ESC does not initialize, i hear no peep tone from the ESC.
I have a Ultra Guard parallel connected. The behavior is too rare that it makes sense to disconnect the Ultra Guard.

[weixelgeist]

Yes, now it was sent to you with instruction.

Thank you, now with the new bootloader it works.

[weixelgeist]

Yes, now it was sent to you with instruction.

Thank you, now with the new bootloader it works.

No, the problem persists also with the new bootloader

[ZeXx86]

Can you describe your full setup please?

You said it is appearing 1 from 3 times. Today is it same again?