I have 3 units of the earlier spirit. all of them worked well. lately, when I'm trying to use wizard to configure units on other helis, servos are frizing when ariving calibration. Checked cables, software is updated, can't find the problem. ideas?
Tnx
new problem
Incorrectly set values for servos - frequency and center in the Servos tab.
Spirit System (Spirit W1, RS & GTR & all the others)
Spirit Wave & JETI DS 12
http://www.habada.cz
Spirit Wave & JETI DS 12
http://www.habada.cz
Hello,
servos should freeze during Subtrim configuration.
You have to set Subtrims and unit should not react to any movement of the model.
In next step unit will switch to other mode.
servos should freeze during Subtrim configuration.
You have to set Subtrims and unit should not react to any movement of the model.
In next step unit will switch to other mode.
Spirit System developer