Throttle channel doesn't go below -13% and stuck on Idleup.

[Lee Jordan]

For throttle hold you should set -100% in your radio. This should correspond to 0%. But only if your channel travel is set to a lower percentage. Because SBUS output from TX16S is different than for Futaba.

The Channel monitor on my tx shows -100% when I hit throttle hold.
But spirit software showes -13%.

I am now confused of what to expect.
Should I expect 0% on screen?

Sent from my Redmi Note 8 Pro using Tapatalk

[ZeXx86]

Yes, you should expect 0%.
This mean that your throttle channel was still not adjusted correctly and has default range.

[Lee Jordan]

Yes, you should expect 0%.
This mean that your throttle channel was still not adjusted correctly and has default range.

Wow.. how have I missed it !?
I actually fly like this 3 other helis.

Can you point me to the place on the manual where it is discussed?

Thank you

Sent from my Redmi Note 8 Pro using Tapatalk

[Mattes61]

Hello Lee Jordan,
I think you should reach "0" in the spirit settings in the diagnostic tab !

You should increase the value for the throttle hold setting (from -100 to -87?) until the exact value "0" is reached in the diagnostic tab (throttle) - this is only a matter of setting in the remote control, not in the FBL -

Best Regards
Mattes61

[Lee Jordan]

Hello Lee Jordan,
I think you should reach "0" in the spirit settings in the diagnostic tab !

You should increase the value for the throttle hold setting (from -100 to -87?) until the exact value "0" is reached in the diagnostic tab (throttle) - this is only a matter of setting in the remote control, not in the FBL -

Best Regards
Mattes61

Thank you.
I will do that.

Anyway, I did the test flight and heli flies real nice regardless of this throttle hold issue.

Cheers

Sent from my Redmi Note 8 Pro using Tapatalk