Futaba Transmitter setup Function " Return to Home Modes"

[Dr.Fleming]

Hello, now we going to better weather and Flying Test phase starting again, so I try like last year,
to setup the mode in the Function "Return to Home", I only can adjust the mode 1, also I try with Endpoint,
Subtrim everything but no way ! My target is to set it up to Mode “4” !

[urgno]

have you assigned a channel to geolink function return to home ?
( F: GeoLink Return to Home in the General/Channels )

if you assigned return to home to Stabi function, then you cannot select mode

from manual:
> If Return to Home is engaged by assigned GeoLink channel there is possibility to use tri-state switch

http://manual.spirit-system.com/index.p ... rn_to_Home

[Dr.Fleming]

Thanks a lot for answer, but Exist the possibility to activate the function Return to Home with Stabi !??

have you assigned a channel to geolink function return to home ?
( F: GeoLink Return to Home in the General/Channels )

if you assigned return to home to Stabi function, then you cannot select mode

from manual:
> If Return to Home is engaged by assigned GeoLink channel there is possibility to use tri-state switch

http://manual.spirit-system.com/index.p ... rn_to_Home

[urgno]

yes you can have stabi + return to home toghether
but then you cannot choose the "mode" of rth

look at 6.2 Modes
at this link

http://manual.spirit-system.com/index.p ... rn_to_Home