Hi there, I have tried to find info about the laser on Geolink v2 - obviously it is below the device, where the golden pattern is in the little box on one side, right? Is it's direction 90° from the devices box to the ground?
If I create my own mount with my 3D printer, do I have to make sure, that the way to the ground is free - so nothing is covering this part of the device? How do you do that with the big tail boom of a Kraken 580 - now way can this laser have visivble sight to ground, if mounted on top.
I'm just collecting ideas to solve this - if the laser is really needed - is it?
A lot of questions for which I haven't found any answers yet.
Thanks for your hints,
Oliver
Where is the laser and do I need to keep free of it?
-
Dr.Fleming
- Posts: 216
- Joined: Sun 18. Apr 2021 16:54:57
It not must be all the time on the boom! 
madman wrote:Hi there, I have tried to find info about the laser on Geolink v2 - obviously it is below the device, where the golden pattern is in the little box on one side, right? Is it's direction 90° from the devices box to the ground?
If I create my own mount with my 3D printer, do I have to make sure, that the way to the ground is free - so nothing is covering this part of the device? How do you do that with the big tail boom of a Kraken 580 - now way can this laser have visivble sight to ground, if mounted on top.
I'm just collecting ideas to solve this - if the laser is really needed - is it?
A lot of questions for which I haven't found any answers yet.
Thanks for your hints,
Oliver