Hello, I need a recommendation for parameterizing the rescue function and stabilizing with as few channels as possible.
I need:
Mode 1: normal flight mode
Mode 2: Stabilization
Mode 3: Rescue function
Can you set the fact that you only need one channel for it? Ideally via a 3-way switch with one channel. Or what is the best way to set the recommendation?
Thanks for the info.
Rescue and stabilization Function wird one Channel?
Hi!
The easiest way to use different stabi functions is to use bank switching. You can set up 3 banks, after it you can switch between them with a 3 way switch.
The easiest way to use different stabi functions is to use bank switching. You can set up 3 banks, after it you can switch between them with a 3 way switch.
Jeti DS12, Align T-Rex 470L with Spirit GTR, Soxos Strike 7 with Spirit GTR
If you need to use only one channel for all these functions then you really need Bank Switching.
Then Unassign Gyro Gain channel in the General - Channel and set it in the Sensor Tab to a minus value. For example -50% if you are using 50% Gyro Gain normally.
Then for each bank set different Stabi/Function and it will work well in this way.
Then Unassign Gyro Gain channel in the General - Channel and set it in the Sensor Tab to a minus value. For example -50% if you are using 50% Gyro Gain normally.
Then for each bank set different Stabi/Function and it will work well in this way.
Spirit System developer