Servo frequency and pulse settings for motor driven tail

[Colin]

I’ve been playing around with a motor driven tail on a Trex 500 with a spirit pro, can anyone tell me the frequency and pulse settings in the wizard’s servo set up page??

[ZeXx86]

Please specify what is ESC that you are using.
This is the most important thing for motor drives.
The most ESCs are not sufficient for tails, because they can`t handle more than 120Hz or will ignore higher frequencies.

[Colin]

I will be using a HobbyWing 60A platinum v4 ESC in airplane mode with a BrotherHobby Avenger V2 2507 1750 Kv motor , I got the motor detail from https://grabcad.com/library/500-size-ga ... ron-duct-1 and sized the esc according to motor Kv and using a 6 cell lipo.

[ZeXx86]

You can try to use 120 - 200Hz there.
Pulse is 1520us.

Please dont forget to set Rudder Control Type parameter to Motor in the Advanced - Expert settings.

[jasc]

If you are brave you could also look at this project
https://github.com/rotorflight/rotorflight