I would like to use both the HOTT integration and have the telemetry data of my Kontronik controller in the transmitter. My problem: Both require connection via the telemetry port on GR24. How can I do it? Y-cable? I think I read that you can also connect and loop through the telemetry from the controller to the Spirit SAT1. Is that possible? What needs to be set there? Will telemetry then be displayed in the telemetry menu of the transmitter?
My configuration:
Kontronik Kolibri 90v
Graupner GR24
Graupner MZ24pro
Spirit pro FBL
Alternatively, I have a Jive pro 80 - here the telemetry could then be realized via the TelMe.
Thank you for your help
Telemetrie and HOTT Integration by only one telemetrie port?
Hello,
you can use Spirit ESC telemetry and wire it according ESC telemetry pages for both ESCs.
you can use Spirit ESC telemetry and wire it according ESC telemetry pages for both ESCs.
Spirit System developer
It should work.
Spirit System developer
TelMe telemetry for all Kontronik ESCs, except standard - old Jive.
Spirit System developer
I have now connected this - but I don't see any telemetry values (everything stops at zero - no RPM, for example). Do I have to set something on the Graupner GR24 receiver? The Sprit Manual says something about "sensor to Chx" However, I can't find this option. In addition, it says that I should set the telemetry input to General. Where do I set this?
I'm not sure if the MZ24 works the same as the MZ32 but I had no telemetry until I watched a youtube video and realised that in the TX telemetry screens I was using the RX widgets and had to change them to the Gen widgets . Now everything works
Yes, GEN = General sensor.
There are shorter names in some HoTT radios.
Great it works now.
There are shorter names in some HoTT radios.
Great it works now.
Spirit System developer