Hi all,
I’m about to change my servo pulse to 720us. Does anybody know of all of the subtrims have to be reset after doing this? I.e redo the FBL setup process for a level swashplate, 0 degrees and 6 degrees geometry.
Changing servo from 1520us to 720us
Hi,
it might be needed to adjust again:
1. all servo subtrims
2. all servo limits
3. Geometry 6°
Adjustments must be done in this order. It is very dependent on servos, but there is possibility there will be difference.
it might be needed to adjust again:
1. all servo subtrims
2. all servo limits
3. Geometry 6°
Adjustments must be done in this order. It is very dependent on servos, but there is possibility there will be difference.
Spirit System developer