Ever since I switched to Software update 3.5, my auto-bailout is not working properly and ultimately did not prevent 3 crashes on 3 different helicopters which under software update 3.4 would have never happened.
I know that the altitude based auto bailout is being set properly and responds properly when activated, but does not respond properly when real time flying mistakes occur under software rev. 3.5
Do you have any thoughts on why this is occuring on 3 different helicopters all after software rev. 3.5 was installed.
All the best,
Ken
Altitude Bailout not working
Hello,
settings for Altitude Limit is different for version 3.4 and 3.5. Please make sure to read ChangeLog when updating to a new versions.
There you can see all differences in the behavior.
This mean that you have to reconfigure the settings, because some parameters have changed.
settings for Altitude Limit is different for version 3.4 and 3.5. Please make sure to read ChangeLog when updating to a new versions.
There you can see all differences in the behavior.
This mean that you have to reconfigure the settings, because some parameters have changed.
Spirit System developer
