Additional servo for retracts | Micro Spirit | Blade 230

3D3D3D · Fri 25. Aug 2023 6:23:27

On the Blade 230 Helicopter (with Spektrum DSMX Satelite) I have all channels occupied except for the Rudd channel. I installed the ESC on the AUX channel as per the instructions and the signal line for the rear motor on channel 4 (I think). Now I need an extra servo for a retractable landing gear. Can I use the Rudd channel on the micro spirit for this?

Thanks in advance

Best Regards

Mattes61 · Fri 25. Aug 2023 21:28:58

Hello,
in my opinion is this not possible - the GT for example has the possybility for Output at channel 0 or Aux2 you see that in spirit settings in channel/function there is no possibility to Output to RUD !

Regards

3D3D3D · Sat 26. Aug 2023 4:10:52

Mattes61 wrote:Hello,
in my opinion is this not possible - the GT for example has the possybility for Output at channel 0 or Aux2 you see that in spirit settings in channel/function there is no possibility to Output to RUD !

Regards

Thanks for your feedback! I also think that it is not possible.. But I still hope that it is somehow possible..