[SOLVED] Settings in Spektrum Tx Causes Unresponsiveness

[doingmainestuff]

I'm running four GT units now, and after adjusting settings in my iX 14 transmitter, two of them do not respond to any stick input after I exit.

Specifically, when I check the tail sub-trim and exit the menu, the GT is unresponsive. I have to power cycle to get it back in use.

Doing the same checks on my laptop does not cause any issues.

Is this a known issue? I completely reset the GT unit on my Align 550X to see if that resolved the problem, but the problem persists on my Goblin 420.

[doingmainestuff]

I can confirm that 3.6.0 fixes this issue!