- Spirit RS and Spirit GTR units:
- Support for external Spirit Wave Receivers.
- From now you can connect external Wave Receiver such as Spirit RX7 and control model from a Wave radio.
- You will need '''JETI Integration Cable''' for wiring at the RUD port + AIL pin.
- Updated support for CRSF/ELRS telemetry:
- Compatibility with Radiomaster ELRS receivers.
- Throttle safety Locking feature:
- You can Enable or Disable Throttle in the Spirit Settings to prevent Motor from spooling up accidently during configuration.
- Bottom side of the Spirit Settings software has Throttle checkbox for enabling/disabling the motor.
- Motor is reenabled automatically as soon as Throttle is set to Hold in case Throttle channel is High when closing the software.
- The last settings is automatically saved so whenever software is started it can avoid a problems.
- Setup Menus:
- In case Throttle was High Setup Menus were turned off automatically with 3.7.0, this has changed now.
- Spirit will not affect these menus anymore, instead Throttle can be Disabled with new Locking feature.
- Receiver Changing:
- Fixed a random error after changing between Receiver Type settings.
- Setup Wizard:
- Setup Wizard has Receiver Wiring schemes for Spirit W1 units.
- Added possibility to set FPORT and CRSF with older Spirit units in the Setup Wizard.
- Spirit RX protocol:
- Support for OTA update for all Spirit units, except Spirit 1.
- Firmware can be updated wirelessly directly from Spirit Wave radio starting from this firmware.
- To enable the support firmware 3.7.1 must be flashed first with Spirit Settings software (together with Spirit RX firmware).
NOTE: No need to change any parameter after Update from 3.7.0 firmware.