Hallo,
ich wollte mein W1 auf 3.7.2 updaten.
Dazu habe ich die Wave eingeschaltet und das W1, das im Heli eingebaut ist, über den Flugakku bestromt.
Dann in der Wave auf Update und schon ging es los.
Jetzt hab ich seit 45 min auf der Wave "Schreibe und 7%" stehen.
Ausstecken ist wahrscheindlich keine gute Idee.
Was kann ich machen?
Update W1 über Wave bleibt hängen
Hello,
wireless updating should take no more than 2 minutes normally.
Please unplug the unit - this will not cause anything wrong fortunately. Then update Spirit Wave to the latest firmware 1.0.19. Then we recommend updating also Receiver firmware to the latest version too (1.10.5).
Please make sure there is no strong source of interference, because when doing update data are checked. If they were received incorrectly then transmission is repeated until it is correct.
Alternative solution is - you can update both Spirit W1 and internal receiver with PC software.
wireless updating should take no more than 2 minutes normally.
Please unplug the unit - this will not cause anything wrong fortunately. Then update Spirit Wave to the latest firmware 1.0.19. Then we recommend updating also Receiver firmware to the latest version too (1.10.5).
Please make sure there is no strong source of interference, because when doing update data are checked. If they were received incorrectly then transmission is repeated until it is correct.
Alternative solution is - you can update both Spirit W1 and internal receiver with PC software.
Spirit System developer